SECTION 1 - COMPANY & PRODUCT IDENTIFICATION

Manufacturer's Name:              Excellent Coatings International                                    Prep Date: 03/01/01

Address:                                  10880 Poplar Avenue

                                                Fontana, CA 92337

                                                (800) 473-3817                      

                                                                                               

Product Class:  Epoxy Coating                                                           

Trade Name:  Chemical Mastic  Cm-15 Part A Base     

H.M.I.S. CODES:   H   F   R   P                                    

                                2   3   0   -

SECTION 2 - HAZARDOUS INGREDIENTS

                                                            Weight             Occupt. Exposure Limits          Vapor Pressure

Ingredient                    C.A.S.#            Percent            OSHA PEL    ACGIH TLV         mm Hg & Temp.F

----------------------------------------------------------------------------------------------------------------------------------------

*Xylene                        1330-20-7        10-15               100ppm           100ppm           5.1                   68

Glycol Ether PM

   Acetate                     108-65-6          1-2                   Not Established                        Not Established.

Liquid Epoxy Resins    Mixture             24-29               Not Established                        Not Established

Nonyl Phenol               25154-52-3      4-5                   Not Established                        <1                    68

Silicon Dioxide             14808-60-7      38-42               Not Established                        Not Established

 

*Indicates toxic chemical(s) subject to reporting requirements of Section 313 of Title III and of 40 CFR 372.

SECTION 3 - PHYSICAL DATA

Boiling Range (Deg. F):  280°F                                                           Vapor Density: Heavier than air

Evaporation Rate:  Slower than Ether

Percent Volatile By Volume:  22                                                           Weight Per Gallon (lbs.): 14.2 ± .5

SECTION 4 - FIRE & EXPLOSION DATA

Flash Point (Deg. F):  80°F                                                                               Lower Explosive Limit:  1.0.

Extinguishing Media:  Foam, alcohol foam, CO2, dry chemical, water spray

OSHA Flammability Classification:  Flammable Liquid IC

 

Special Firefighting Procedures:  Wear a NIOSH/MSHA approved self contained breathing apparatus and full protective clothing.  Use water to keep fire exposed containers cool.  

 

Unusual Fire & Explosion Hazards:  Vapors are heavier than air and may travel along the ground or be moved by ventilation to ignition sources at locations distant from material handling point.  Pressure may build up in containers and create an explosion hazard.

 

SECTION 5 - HEALTH HAZARD DATA

THIS PRODUCT IS FLAMMABLE

Effects Of Overexposure:

Eyes:  Irritation, burning, tearing and redness.

Skin:  Moderate irritation or defatting of skin upon prolonged or repeated contact.

Ingestion:  Abdominal pain, nausea, vomiting and diarrhea.

 

Cont. Section 5 - Health Hazard Data

Inhalation:  Excessive exposure to vapors can cause headache, dizziness, uncoordination, nausea and loss of consciousness.

 

Emergency & First Aid Procedures:

Eyes:  Flush with water for 15 minutes.

Skin:  Remove contaminated clothing, wash skin with soap and water.

Ingestion:  Do not induce vomiting.  Get medical attention immediately.

Inhalation:  Move to fresh air, aid breathing if necessary.

 

In all cases, consult a physician for best treatment.

 

Chemical listed as carcinogen or potential carcinogen:

NTP:  No           IARC:  No           OSHA:  No

SECTION 6 - REACTIVITY DATA

Stability: Product Stable              

Conditions to Avoid:  All sources of ignition

Incompatibility (Materials to Avoid):  Oxidizing agents, strong acids & bases

Hazardous Decomposition Products:  Carbon monoxide, carbon dioxide, nitrogen oxides and organic compounds.

Hazardous Polymerization:  Will Not Occur

SECTION 7 - SPILL OR LEAK PROCDEURES

Steps To Be Taken In Case Material Is Released Or Spilled:  Dike spill area.  Absorb spill with inert absorbent material.  Place in sealed metal containers for proper disposal.

 

Waste Disposal Method:  Dispose of in accordance with local, state and federal regulations.

SECTION 8 - SPECIAL PROTECTION INFORMATION

Respiratory Protection:  Use a NIOSH/MSHA jointly approved respirator

Ventilation:  Use mechanical ventilation

Protective Gloves:  Neoprene or rubber

Eye Protection:  Chemical splash goggles

Other Protective Equipment:  Protective clothing, barrier cream, eye bath, safety shower

SECTION 9 - SPECIAL PRECAUTIONS

Precautions To Be Taken In Handling & Storing;  Store in dry area.  Keep away from open flames and high temperatures.

 

Other Precautions:  Minimize contact.  Avoid breathing vapors.  Practice good industrial hygiene and safe working practices.